Bison Designs Belts Size Chart
Bison Designs SINGLE PLY WEBBING Belts Sizing Guide
*These sizes are recommended to allow a 6" tail of excess to pull through belt loops.
**TRIM TO FIT: This belt can be trimmed to fit. Trim the tail end of the belt with a pair of scissors to your desired length. Prevent fraying by sealing the edge with a flat heat source, such as the flat side of an iron, turned up to the hottest setting. Once the iron is cool any residue will wipe off.
**TRIM TO FIT: This belt can be trimmed to fit. Trim the tail end of the belt with a pair of scissors to your desired length. Prevent fraying by sealing the edge with a flat heat source, such as the flat side of an iron, turned up to the hottest setting. Once the iron is cool any residue will wipe off.
| Size | Total Length (in.) | Max Waist (in.) |
|---|---|---|
| M | 44 | 38 |
| L | 48 | 42 |
| XL | 52 | 46 |
Bison Designs HEAVY DUTY Belts Sizing Guide
*Heavy Duty Belts are 2 ply webbing, reinforced with 12 feet of sewing. These belts are completed with a Velcro closure.
| Size | Total Length (in.) | Max Waist (in.) |
|---|---|---|
| S | 47 | 32 - 36 |
| M | 50 | 36 - 40 |
| L | 54 | 40 - 44 |
| XL | 61 | 46 - 50 |
Bison Designs LEATHER BELTS Sizing Guide
* For the perfect fit, order ONE SIZE LARGER than your pant size.
Bison Design's sizing is measured from the third hole to the end of the leather near the buckle in inches.
Dress belts should have a few inches of leather to the left of the buckle once it’s fastened. Enough to tuck under your first belt loop.
Bison Design's sizing is measured from the third hole to the end of the leather near the buckle in inches.
Dress belts should have a few inches of leather to the left of the buckle once it’s fastened. Enough to tuck under your first belt loop.
| Size | Total Length (in.) | Max Waist (in.) |
|---|---|---|
| 30 | 36 | 30 |
| 32 | 38 | 32 |
| 34 | 40 | 34 |
| 36 | 42 | 36 |
| 38 | 44 | 38 |
| 40 | 46 | 40 |
| 42 | 48 | 42 |
Bison Designs LEATHER TIP Belts Sizing Guide
*These sizes are recommended to allow a 6 inch tail of excess to pull through belt loops.
**TRIM TO FIT: This belt can be trimmed to fit. Trim the tail end of the belt with a pair of scissors to your desired length. Prevent fraying by sealing the edge with a flat heat source, such as the flat side of an iron, turned up to the hottest setting. Once the iron is cool any residue will wipe off.
| Size | Total Length (in.) | Max Waist (in.) |
|---|---|---|
| S | 40 | 34 |
| M | 44 | 38 |
| L | 48 | 42 |